M134 Components

• 3 piece rotor design with replaceable parts for indefinite life span rotor design with replaceable parts for indefinite life span 

• Replaceable camming section allowing for rotor to be indefinite life span 

• Quick attach bolt tracks for immediate toolless bolt removal or install 

• Ability to accept GE, Dillon Ti or DTV quick attach guide bars 

• Available in titanium or stainless steel 

• Ability to take any manufacturers parts from any generation of M134

• 4.25lb yokeless housing with mounting arm adapter installed (competition’s housing is 4.1 pounds without heavy and cumbersome yoke)

• Quick attach guide bar for fast and toolless guide bar changes

• Ability to take all legacy components making it completely backwards compatible

• Guide bar is designed to assist in the use of plastic ammunition

• Machinable body making all components on entire assembly replaceable for infinite life span, easy to service and lighter.

• Two-part paddle wheel that encapsulates the round while circulating through its feeding path in the delinker.  Between the two paddle wheels is a center cam that guides the middle of the round, giving three points of contact, front, middle and rear all while the two paddle wheels fully encapsulate the round, so the feed path is perfectly stable mitigating any issues that could arise like round yaw.

• Multi caliber configurable with a simple swap of the front paddle wheel using our patented technology of a quick locking delinker nose. Simply twist 20 degrees in either direction and the nose of the delinker now comes off, no tools necessary.

• Roughly 1.5 pounds lighter than a Dillon Aero Titanium delinker.

• Loaded round indicator on the rear delinker door allowing the operator to visibly see if the delinker is loaded or able to feel the indicator at night in low illumination.

• Round push rods for straight and consistent delinking of rounds with a cleaner push.  Push rods also have a clearance pocket in case of a non-fully seated primer, they will not set off the primer unlike legacy delinkers.

• Drive gear is keyed to push rod guide and not reliant on a roll pin for stability and timing and can not shift under catastrophic failure anymore.

• Safing sector allows gun to run under power and not fire ammunition

• Safing gate safes and arms the weapon

• Top cover allows bolts to be removed from gun with no tools or removal of any parts but a quick attach rotor track

• Battery fits inside spade grips

• Light weight

• Eliminates power cables and external power sources

• 8S lithium-Ion battery

• Removeable and rechargeable

• 30,000+ round capacity

• Legacy motor compatible so spade grip assembly can immediately be adapted to any current legacy M134 

• Can use legacy DC power cable if operator chooses to not run battery pack

True variable speed triggers

• Intuitive, rate of fire proportional to trigger travel

• Available custom min and max rate of fire configurations

• Get on target faster with less ammo due to reduced start up “over-torque” effect.

• 30,000+ rounds of power in a removeable and rechargeable battery 

• Lightweight (4lbs)

• Fits inside spade grips

• 13.6 Ah

• Simple two-part design using a single cross pin. 

• Permanently attaches to clutch and spade and still allows normal disassembly of the clutch with no additional steps. 

• Slide spade grip assembly onto clutch bracket and secure with single cross pin for tight lockup. 

• Legacy compatible. Will fit on competitors spade grips and clutch. 

• Modular suppressor that is length configurable 

• Eliminates almost all flash when firing 

• Keyed locking lugs make assembly simple and straightforward 

• Never has to be removed from barrel clamp and retains the ability to slide on and off the barrels with no extra steps